« previous next »
Pages: [1]   Go Down

Author Topic: Recoil Spring for Tanfoglio Limited 9mm question  (Read 1071 times)

0 Members and 1 Guest are viewing this topic.

Offline Litespeeds

  • Full Member
  • ***
  • Posts: 111
Recoil Spring for Tanfoglio Limited 9mm question
« on: December 04, 2018, 01:34:11 AM »
I have a Tanfoglio Limited in .40S&W and recently bought a replacement bull barrel in 9mm. I am having some failures to eject and most likely because the recoil spring is too heavy.  Do you know what weight spring that I will need to get?   Anyone know what the factory recoil spring weights are for the Limited in 9mm and .40S&W?
Logged

Offline jwc007

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 8723
Re: Recoil Spring for Tanfoglio Limited 9mm question
« Reply #1 on: December 04, 2018, 01:49:32 PM »
Quote from: Litespeeds on December 04, 2018, 01:34:11 AM
I have a Tanfoglio Limited in .40S&W and recently bought a replacement bull barrel in 9mm. I am having some failures to eject and most likely because the recoil spring is too heavy.  Do you know what weight spring that I will need to get?   Anyone know what the factory recoil spring weights are for the Limited in 9mm and .40S&W?

Standard Factory Spring weights for the Full Size 9mm Tanfoglio Witness Pistols run 14/15 lbs and that is what I would recommend for standard power 9mm ammunition.
If you are running Minor Power Factor Target Loads, perhaps a Wolff Recoil Spring Calibration pack would be best to experiment with.
Logged
"Easy is the path to wisdom for those not blinded by ego." - Yoda


For all of those killed by a 9mm: "Get up! You are not dead! You were shot with a useless cartridge!"

Offline Frank72

  • Jr. Member
  • **
  • Posts: 45
Re: Recoil Spring for Tanfoglio Limited 9mm question
« Reply #2 on: December 19, 2018, 07:04:57 AM »
Which bull barrel did you buy for your limited? That sounds like a great route for my Witness Match.

Thanks!
Logged
Pages: [1]   Go Up
« previous next »