Author Topic: Trigger Pull on a Out of the Box P-07  (Read 932 times)

0 Members and 3 Guests are viewing this topic.

Offline timetofly

  • Sr. Member
  • ****
  • Posts: 801
Trigger Pull on a Out of the Box P-07
« on: March 10, 2019, 12:17:08 PM »
I picked up a NIB P-07, 2014 vintage, in 40 S&W yesterday.  I cleaned and lubed it up and the trigger pull according to my inexpensive Wheeler 8 oz to 8 lb trigger pull scale, the SA trigger pull started at 4.2 lbs. After dry firing with snap caps about 300 times, the SA trigger pull went down to about 3.5 lbs to 3.75 lbs, but looked like 3.5 lbs is where it was heading.   DA trigger pull exceeded 8 lbs.  The red line indicates where the trigger pull scale was during the testing.  Above there was a flat area and the pull scale would slide off it and settle lower.

I would assume that the "stock" SA trigger pull would settle in the 4.25 lb range.  What is the normal "stock" SA trigger pull range for the Omega trigger?  Any info would be greatly appreciated.

All of life’s journeys begin by putting one foot in front of the other.

Offline DOC 1500

  • Hero Member
  • *****
  • Posts: 1940
Re: Trigger Pull on a Out of the Box P-07
« Reply #1 on: March 10, 2019, 12:56:00 PM »
Wow ,8.8DA   and 3.75 SA
 consider yourself one of the lucky ones with a good trigger.👍👍
They don't always come out of the box like that.
With polishing and change a few Springs,  it can be a whole lot more if you want it to be. Especially the smoothness.
JOHN 3:16
2 COR.5:17
A Lie is a Lie even if everybody believes it ,
The Truth is the Truth even if nobody believes it !!!

Offline SI VIS PACEM PARRABELLUM

  • Hero Member
  • *****
  • Posts: 5825
Re: Trigger Pull on a Out of the Box P-07
« Reply #2 on: March 10, 2019, 06:50:27 PM »
Not really any norm that can be stated. These are purely service grade guns out of the box and the readings can vary wildly. Best advice is if you are not satisfied with the current readings invest in some CGW upgrades. My particular P-07 was really smooth in DA and fairly crip in SA but after the addition of the CGW spring kit, hammer and srs system it is as good as any custom revolver in DA and rivals high end 1911's in SA.