CZ PISTOL CLUBS > CZ Polymer Pistols: P10, P-07, P-09

P09 project

<< < (2/3) > >>

Tok36:
^^Sounds neat. What did the SAO conversion on your P-09 require?

GMP:

--- Quote from: Tok36 on November 17, 2019, 01:47:33 AM ---^^Sounds neat. What did the SAO conversion on your P-09 require?

--- End quote ---

I removed the front block, fit a cross pin in the well of the frame, and notched the lower front edge of the block to perfectly capture it.  The the mating edge of the trigger was fit for perfect reset.  Also added overtravel stop.  The stock trigger pin was sloppy, seems like the relief for the spring was too wide and the right ear of the trigger would fall into the gap giving an inconsistent  feel.  I made a new pin from drill rod and captured it with 6mm long roll pins on each side.  Much better. 


[Mods corrected typo]

Tok36:

--- Quote from: GMP on November 19, 2019, 08:57:32 AM ---
--- Quote from: Tok36 on November 17, 2019, 01:47:33 AM ---^^Sounds neat. What did the SAO conversion on your P-09 require?

--- End quote ---

I removed the front block,  fit a cross
pin in the well of the frame,  and notched the lower front edge of the block to perfectly capture it.  The the mating edge of the trigger was fit for perfect reset.  Also added overtravel stop.  The stock trigger pin was sloppy,  seems like the relief for the spring was too wide and the right ear of the trigger would fall into the gap giving an inconsistent  feel.  I made a new pin from drill rod and captured it with 6mm long roll oins on each side.  Much better.

--- End quote ---


Thank you for the details GMP, interesting stuff. What are the "6mm long roll oins" that you mention? While i recognize that not everyone is into posting pictures, if you ever get the urge to post some entailing your conversion i would look at them.  :) I have heard very little about CZ P Series SAO conversions.

Wobbly:

--- Quote from: Tok36 on November 19, 2019, 05:39:45 PM ---What are the "6mm long roll oins" that you mention?

--- End quote ---

Probable typo. Try "6mm long roll pins".

Tok36:

--- Quote from: Wobbly on November 19, 2019, 07:38:35 PM ---
--- Quote from: Tok36 on November 19, 2019, 05:39:45 PM ---What are the "6mm long roll oins" that you mention?

--- End quote ---

Probable typo. Try "6mm long roll pins".

--- End quote ---

Ahh, good point.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version