« previous next »
Pages: [1]   Go Down

Author Topic: SA/DA pull weights after polishing and CGW install  (Read 1709 times)

0 Members and 1 Guest are viewing this topic.

Offline SEAKPhotog

  • Full Member
  • ***
  • Posts: 230
SA/DA pull weights after polishing and CGW install
« on: March 17, 2020, 02:41:40 AM »
So I recently bought a CZ 97BD with the intention of making it the first CZ I completely tear down, polish and upgrade with CGW parts. I have an SP01 that's been to CGW for a pro package install and optics cut and a PCR there now for the same treatment. I figured it was about time to learn to do the polishing and kit install myself, both to save money and time and also to learn the gun and improve my gun tinkering confidence.  Using YouTube vids and the gunsmithing forum here it was a snap. After a good polish I ended up installing the CGW pro package and an 11.5 lb hammer spring. My DA is now 6lbs 3oz and my SA is a crazy nice 2lbs 11oz (sadly I don't have before measurements). Wow. It shoots like a dream. It'll be used for steel plate and fun range stuff. I highly recommend trying out a do it yourself CZ project. If I can pull it off without too much angst anybody can. And hell, if you break any bits and pieces replacements can always be found at CGW or CZ Custom or Numrichs. And CGW is quick to answer any email questions or pleas for help you send their way 😉
Logged

Offline TNman

  • Full Member
  • ***
  • Posts: 279
Re: SA/DA pull weights after polishing and CGW install
« Reply #1 on: March 17, 2020, 05:12:23 AM »
That's a terrific SA pull weight. I tackled  the same project but could not get below 3 1/4 pounds. Mine is the decocker modle and the biggest challenge for me was trying to reassemble the sear  cage. That was a nightmare.

Sent from my SM-G960U using Tapatalk

Logged
IDPA   |   USPSA  |   NRA

CZ PCR   |   RAMI BD   |   Shadow 2   |   P-10 C   |   CZ 75B Omega   |   CZ 97 BD

Sig P320 Comp. & Full & X-Carry
Sig P226 Legion
Springfield XDS Mod 2 45

Offline SEAKPhotog

  • Full Member
  • ***
  • Posts: 230
Re: SA/DA pull weights after polishing and CGW install
« Reply #2 on: March 17, 2020, 01:51:59 PM »
Quote from: TNman on March 17, 2020, 05:12:23 AM
That's a terrific SA pull weight. I tackled  the same project but could not get below 3 1/4 pounds. Mine is the decocker modle and the biggest challenge for me was trying to reassemble the sear  cage. That was a nightmare.

Sent from my SM-G960U using Tapatalk

Re: the sear cage, this video by the forum's own Earl An was key for me:

https://www.youtube.com/watch?v=4vamXokwoWg
Logged

Offline goforbroke

  • Jr. Member
  • **
  • Posts: 33
Re: SA/DA pull weights after polishing and CGW install
« Reply #3 on: March 17, 2020, 11:22:43 PM »
Having the $5 slave pin from CGW does help with assembly of the sear cage. That along with set of electronic tweezers helps. For YEARS I would just use a cut up q-tip as a slave pin(hey it works) but I finally decided to stop being a cheap ass and buy the $5 part.
Logged
Pages: [1]   Go Up
« previous next »