Hogue Beavertail grip on P-07

[GRU7_Mike]

https://www.hogueinc.com/handgun-grips/cz-tz-eaa-witness-sphinx-grips/cz-p-10/p-10-c/cz-p-10-c-handall-beavertail-grip-sleeve-black

Does anyone have a Hogue beavertail grip on their P-07?  I can not find one for the P-07 but did find one for the P-10c.  I do not have access to a P-10c but all that I can find as comparison they look like the grip should fit both models.

[Earl Keese]

https://www.hogueinc.com/handgun-grips/cz-tz-eaa-witness-sphinx-grips/cz-p-10/p-10-c/cz-p-10-c-handall-beavertail-grip-sleeve-black

Does anyone have a Hogue beavertail grip on their P-07?  I can not find one for the P-07 but did find one for the P-10c.  I do not have access to a P-10c but all that I can find as comparison they look like the grip should fit both models.

I have one coming Monday for my P10C. Will try it on my P07 and post a pic or two.

[puddintame]

i wish the P10c in that pic was in my safe. if it doesnt fit, i used this one on my P07. no beavertail pad though

[Earl Keese]

Sorry I didn't get back sooner. I did get the Handall for my P10C. My intention was to try it first on my P07, but it was so different I didn't bother. The beavertail contour is much different and the p07 grip is too short to fit. FWIW, the handall was extremely difficult to install on the P10, even with the small back qstrap.

[GRU7_Mike]

Thanks for the reply....the more I looked at the P-10 compared to the P-07 I saw there might be a problem with the fit....now I know for sure.  Sure do wish CZ or LOK would come up with some ingenious way to create replaceable grips on the P models!

[CCWLearner]

It doesn't have the beavertail, but the Hogue Handall tactical model 17210 will fit a P-07 after you cut it down with some scissors or a razor.

https://www.hogueinc.com/handall-tactical-grip-sleeve-large-black

I used to run these on my P-07's with the small backstrap, but ended up moving to the medium backstrap with rubber Talon grips.