« previous next »
Pages: [1]   Go Down

Author Topic: CZ P-10c Stippled and coated.  (Read 967 times)

0 Members and 1 Guest are viewing this topic.

Offline TRAK

  • Newbie
  • *
  • Posts: 23
CZ P-10c Stippled and coated.
« on: September 12, 2020, 08:13:11 PM »
Not my best work but I was in a little hurry this week.. I just did a simple stipple following the CZ lines and then blasted and coated it in Alumahyde II Earth Brown. It's about as durable as Cerakote but you don't have to start up a compressor and wait for the humidity to drop in the shop before coating.   I still bake at 200 degrees for about 8-12 hours though as it cures it for assembly immediately.  If you think it looks like OD ? It does, Brownells Earth Brown has more green in it than brown. Looks a lot like Magpul OD green to me.

« Last Edit: September 15, 2020, 12:40:21 PM by Wobbly »
Logged

Offline MSteve

  • Jr. Member
  • **
  • Posts: 37
Re: CZ P-10c Stippled and coated.
« Reply #1 on: September 12, 2020, 08:40:43 PM »
Looks great.
Logged
Steve

Offline Porcupine

  • Full Member
  • ***
  • Posts: 116
Re: CZ P-10c Stippled and coated.
« Reply #2 on: September 14, 2020, 01:03:05 PM »
While I’m not generally a fan of stippling, that looks very nice.

Well done.
Logged
Pages: [1]   Go Up
« previous next »