« previous next »
Pages: [1]   Go Down

Author Topic: CGW Steel striker question  (Read 315 times)

0 Members and 1 Guest are viewing this topic.

Offline Vizsladog

  • Jr. Member
  • **
  • Posts: 28
CGW Steel striker question
« on: November 17, 2020, 02:47:32 PM »
Anyone using the newest version? Hows it working?
Logged

Offline Horn78

  • Newbie
  • *
  • Posts: 22
Re: CGW Steel striker question
« Reply #1 on: November 18, 2020, 02:59:47 PM »
Look down below at my thread... https://czfirearms.us/index.php?topic=113076.0

Long story short the striker was fine but the CGW spring was allowing the spring retention cups to open and letting the spring loose. CGW told me to file or flatten the ends of the spring but I am not trusting that and using a reduced trigger pull spring that came with my HBI trigger. Works fine with the new CGW striker.
Logged

Offline jpeto

  • Jr. Member
  • **
  • Posts: 66
Re: CGW Steel striker question
« Reply #2 on: November 18, 2020, 06:53:30 PM »
I had an issue a few months back with the cgw striker in a P10c. The base of the tip was too big and was getting caught in the breach face every time. You wouldn’t notice until trying to rack the slide ( started during dry fire, using a snap cap) and it wouldn’t budge without really smacking it. I let cgw know about it and they sent a new one out and it works great so far. Without measuring, I assume the base of striker tip isn’t as fat anymore


Sent from my iPhone using Tapatalk
Logged
Pages: [1]   Go Up
« previous next »