« previous next »
Pages: [1]   Go Down

Author Topic: Front Sight Problem  (Read 1412 times)

0 Members and 1 Guest are viewing this topic.

Offline Sunkist

  • Full Member
  • ***
  • Posts: 346
  • NRA Instructor: Basic Pistol, Reloading, CCW
Front Sight Problem
« on: November 18, 2021, 01:23:39 PM »
I've replaced factory sights on 5 CZ pistols. I have a new P-01 and want to install Dawson night sights. I can't get the front sight to move even a little. The pin came out as they all have but using the Dawson punch and hitting it way harder than is comfortable it hasn't moved even a hair's width. I've soaked it with Ballistol, let it sir overnight but it hasn't budged. Any tips?
Logged
"In the Land of the Blind the One-Eyed Man is King."

Offline SI VIS PACEM PARRABELLUM

  • Hero Member
  • *****
  • Posts: 5825
Re: Front Sight Problem
« Reply #1 on: November 18, 2021, 03:31:45 PM »
Yep had a couple that were tight like that. You may do what you want but I never intended to reinstall any factory sights so for the ones that would not move I securely clamped the slide in place and used a regular steel punch. This only took a couple good wacks and the sight was out. Yes the sight was ruined but as I said I was never putting them back anyway.
Logged

Offline SoCal

  • Sr. Member
  • ****
  • Posts: 602
Re: Front Sight Problem
« Reply #2 on: November 19, 2021, 12:47:46 PM »
You might try a little heat.
Logged
If I had known how much better being retired is than working I would have done it FIRST.

Offline Fuzzy Sights

  • Hero Member
  • *****
  • Posts: 1210
  • > Dirt
Re: Front Sight Problem
« Reply #3 on: November 19, 2021, 01:24:41 PM »
Had same issue.  Wound up lubing the sight slide interface and put them in the freezer.  Next day secured the slide in a vice and used a lighter to provide heat to the slide around the muzzle barrel channel.  Popped right out on first tap.

Good luck.

JW
Logged
Vivat et res publica!

Think of me as a Newbee who types a lot.

Offline Sunkist

  • Full Member
  • ***
  • Posts: 346
  • NRA Instructor: Basic Pistol, Reloading, CCW
Re: Front Sight Problem
« Reply #4 on: November 19, 2021, 07:07:18 PM »
The Dawson punches didn't pack enough wallop. I went a brass head punch and that got things moving. The sights are on and centered now. Thanks for the replies. I had never run into sights that tight before. Some were close but these took the prize.
Logged
"In the Land of the Blind the One-Eyed Man is King."
Pages: [1]   Go Up
« previous next »