Shadow disconnector in a cz 75 pre B?

[Blueboar]

Has anyone installed a shadow disconnector in a classic pre b cz 75? 

If so were there issues?  What are the expected results,  I am trying to plan improvements to the pre B without losing the spur hammer or change to looks of the gun.  Does anyone know if the adjustable sear would help me if I don't plan on changing the hammer?

Thx in advance. 

[M1A4ME]

I think the CGW adjustable sear is to help overcome a hammer change by adjusting for the different sear position caused by a change in the hammer vs adjustment to affect trigger pull feel or force.

The thumb safety may not be able to rotate into position relative to the factory sear after a hammer change.  The alternatives are removing metal from the cam on the left side safety lever shaft or buying/installing/adjusting a CGW adjustable sear.  I've done both and the adjustable sear take a lot of time, effort and frustration off the table.  Not to mention that if you make a mistake and remove too much metal off that safety cam you'd have to locate and buy a new Pre B safety.  Those may be hard to find these days.

[Redhemi]

I haven't done this but if you are looking to reduce the reach of the trigger I don't believe a stock S2 disconnecter will do this. If you are wanting to reduce the trigger reach both CZC and CGW makes a reach reduction sear that will fit in a pre b model. As for an adjustable sear as said you would only need one if you are going to change the hammer to a CZC or CGW hammer.

[Blueboar]

Thanks for the input.