CGW Pro Kit

[north86]

Hi All,

New here, but not too new to armoring work

I have a P-01, and ordered the CGW Pro kit.  It does NOT come with the slave pin for the sear cage.

I have watched a few videos, where people have used qtips, tooth picks, the main spring pin, etc...  Do I really need this?
 Does anyone have the dimensions for the pin?   Could I make one from stock from the hardware store? 

Thanks in advance!
Joe

[Mk4Zero]

I’ve used a punch and toothpick as a slave pin.  My favorite is a tooth pick as it’s part of my sear cage assembly work flow when installing L spring into FPS—I pull the spring down and then shove it through the whole assembly

[Ktm45]

Try some bamboo skewers . I get them from the market and they come in different sizes.  They are quite tough also. You can [ush on the tip of a spring end even.

[spaceboy]

As others have said, you can get toothpicks or bamboo skewers or Q-tips for nothing or next to nothing. But I actually have my eye on those special spring tools that EemannTech makes:

the trigger return spring tool...
https://www.youtube.com/watch?v=nwx-lZRxUrQ

and the sear spring tool...
https://www.youtube.com/watch?v=noE1VE6NDIQ

I'm too new to CZ's and gunsmithing to have used them personally. And I'm sure many people will ask why they need fancy brass tools at $30-40 each if a toothpick will work. But from the looks of these videos, you can install these springs that people often struggle with in 3 seconds with no problems whatsoever.  Just a thought.

[Philipl]

I have done over a dozen Pro Package upgrades. Initially I used a toothpick but then I bought the EEMANN tools and have been smiling ever since

[DeltaPapa]

Will Eemann ship to the US?  I couldn't find a US dealer shown on their website.

[kabong57]

Locate dealers here;

https://www.eemann.tech/dealers/

[Philipl]

Here

https://www.dot40.net/product-category/eemann-tech/et-cz-parts-tools/page/5/