« previous next »
Pages: [1]   Go Down

Author Topic: Question about coatings.  (Read 1266 times)

0 Members and 1 Guest are viewing this topic.

Offline CZnewbe

  • Full Member
  • ***
  • Posts: 194
Question about coatings.
« on: January 25, 2009, 09:38:27 PM »
I have a S&W that I may refinish.  Through my web research I've seen many different coatings, including Duracoat, Gun Kote, etc., but the only coating I have any personal experience with is the black polycoat on my CZ85B.  How do these other coatings compare to the CZ polycoat? ???
Logged

mbott

  • Guest
Re: Question about coatings.
« Reply #1 on: January 27, 2009, 05:33:01 AM »
I have a Taurus PT1911 that I've been waiting for the (thin) blue finish to wear so I could experiment with a DIY Duracoat finish in Matte Black, but so far, the Taurus refuses to wear enough to get started.

--
Mike 
Logged

Offline William Chase

  • Administrator
  • Hero Member
  • *****
  • Posts: 1570
Re: Question about coatings.
« Reply #2 on: January 27, 2009, 12:38:10 PM »
The AR15.com Refinishing Forum is a good source of opinions on this topic. The closest to a consensus seems to be Norrels Moly Resin, http://www.johnnorrellarms.com/ with Duracoat a close second. I think the closest may be Brownell's new Teflon-Moly, as I've read it tends to be a bit thicker finish.

HTH!
Bill
Logged
"The right to buy weapons is the right to be free". A.E van Vogt
CZ75 P-01   CZ52 (53)  S&W 642  
1903 M96B Carl Gustaf Swedish Mauser Remington 870 Wingmaster 12Ga
USPSA Area 4, Brazosland Pistoleros
Pages: [1]   Go Up
« previous next »