« previous next »
Pages: [1]   Go Down

Author Topic: EAA Witness trigger pin problem  (Read 1625 times)

0 Members and 1 Guest are viewing this topic.

Offline MarvtheGrate

  • Newbie
  • *
  • Posts: 18
EAA Witness trigger pin problem
« on: May 27, 2009, 10:54:58 PM »
I've an EAA Witness - P .45 that has a problem with the hinge pin for the trigger drifting out when used.  I am wondering if anyone else has seen this problem. 
Thanks in advance.
Logged

Offline Tanfoglio

  • Newbie
  • *
  • Posts: 7
Re: EAA Witness trigger pin problem
« Reply #1 on: May 27, 2009, 11:22:28 PM »
Yes, both of my 9mm's have the same problem. 

I just staked it with a pin punch and all is well now.

 

Fred
Logged

Offline MarvtheGrate

  • Newbie
  • *
  • Posts: 18
Re: EAA Witness trigger pin problem
« Reply #2 on: May 27, 2009, 11:28:11 PM »
Thanks, I will give that a go.  I like the Witness, and it's my only .45, but it's clear that fit and finish just are not to par with my other CZs.
Logged

Offline jwc007

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 8760
Re: EAA Witness trigger pin problem
« Reply #3 on: May 28, 2009, 12:34:41 AM »
If that does not cure this problem, just get a new Roll Pin of the appropriate size and replace it.  Just use the shanks of a Drill Bit Set to determine the right size.  A Real Hardware Store and/or Industrial Supply will have them.  Install with the appropriate sized Roll Pin Punch.
Logged
"Easy is the path to wisdom for those not blinded by ego." - Yoda


For all of those killed by a 9mm: "Get up! You are not dead! You were shot with a useless cartridge!"

Offline MarvtheGrate

  • Newbie
  • *
  • Posts: 18
Re: EAA Witness trigger pin problem
« Reply #4 on: May 28, 2009, 01:22:37 PM »
Thank you for the advice.  I will look in to that the next time I shoot it.  I like the .45 and I really like that it has the same feel and operation as my CZs.  I've just been drifting the pin back in each time I take it out.  I will try staking it first to see if that will solve the issue.
Logged
Pages: [1]   Go Up
« previous next »