CZ shotgun

[camcriddle]

I have a CZ semi-auto shotgun that I purchased used 3 years ago.  I have never had a problem until this year.  I will take the first shot, the second round will cycle and load, but will not fire.  I can pop it out and put in a new round and it will shoot it, but not the following rounds.  Prior to taking it to a gunsmith, which are few and far between around here, I wanted to find out if anybody had run into the same issue and what they did to fix it.  Thanks.

[Wahoo1 again]

Had a similar problem with a CZ 712 I use for duck hunting. Just needed a complete take down and through cleaning. Lots of carbon fouling and crud in places I missed during a routine cleaning.  The bolt was not always going fully forward. Looked like it was until I gave the bolt a push with my thumb, moved about 1/8th inch and would then fire.

[czfreak]

you have the problem because they are what they are, a 300 dollar shotgun. clean the living crap out of it or they are no good

[Wahoo1 again]

you have the problem because they are what they are, a 300 dollar shotgun. clean the living crap out of it or they are no good

Tell me are you always this big a jerk?

 My guests and I shoot 1200 to 1500 rounds of 12ga loads from my CZ and Beretta shotguns every waterfowl season, they are equally reliable. I've failed to clean my Beretta A300 thoroughly and had the exact problem.

[czfreak]

like I said, clean the hell out of it....you have a problem?

[Grendel]

And that's quite enough of that.