Author Topic: PCR sights question  (Read 2263 times)

0 Members and 1 Guest are viewing this topic.

Offline *Klutch*

  • Jr. Member
  • **
  • Posts: 25
PCR sights question
« on: March 08, 2015, 08:04:24 AM »
Guys I just picked up a CZ PCR yesterday and I got some meprolights with it but not installed. I would like to know what size is the Allen screw holding the rear sight in? I believe it's 1.5mm but just based on other gun stuffs being that size. Also what size punch do I need for the front pin?

Offline Jackpot

  • Newbie
  • *
  • Posts: 4
Re: PCR sights question
« Reply #1 on: March 11, 2015, 04:45:41 PM »
Hello....sorry I can't help you with your question and I hope you don't mind me asking you one....I just picked up a nib PCR myself and want new sights also..can you tell me the parts number on the sights you found, if you don't mind please....
  It's difficult finding accessories for CZ's...I'm also looking for a single metal clip inside waist leather holster and no luck there yet either....
   Didn't mean to high jack your post , if anything,hopefully this will keep it at the top to get your question answered....

Respectfully, jackpot

Offline *Klutch*

  • Jr. Member
  • **
  • Posts: 25
Re: PCR sights question
« Reply #2 on: March 12, 2015, 06:49:09 PM »
I sent you a pm

Offline CausticAudio

  • Jr. Member
  • **
  • Posts: 41
Re: PCR sights question
« Reply #3 on: April 05, 2015, 12:11:52 AM »
This is a question for the home smithing board. I have a BD and use a 1/16" punch for the pin and somthing like 1/32" for the set screw.