« previous next »
Pages: [1]   Go Down

Author Topic: Decocker sear slave pin length? Anyone know the length so I can make my own.  (Read 1308 times)

0 Members and 2 Guests are viewing this topic.

Offline bgriff008

  • Jr. Member
  • **
  • Posts: 32
Decocker sear slave pin length? Anyone know the length so I can make my own.
« on: July 18, 2016, 07:05:48 PM »
I'm cutting down an old drill bit to use as a decocker sear slave pin. I need to remove the sear controls intact to bead blast my frame for cerakote. So the length of the slave pin is needed. Thanks.
Logged

Offline bgriff008

  • Jr. Member
  • **
  • Posts: 32
Re: Decocker sear slave pin length? Anyone know the length so I can make my own.
« Reply #1 on: July 18, 2016, 08:39:43 PM »
Disregard. I just ordered the slave pin with start punch and some other upgrades from CGW, including spring kit and floating trigger pin.
Logged

Offline Obiwan

  • Full Member
  • ***
  • Posts: 235
Re: Decocker sear slave pin length? Anyone know the length so I can make my own.
« Reply #2 on: July 18, 2016, 11:01:23 PM »
If it's only temporary, why not use the hammer spring retention pin? (the one at the bottom at the grip). Has the perfect length.

Alternatively, a piece of q-tip will work.
Logged

Offline bgriff008

  • Jr. Member
  • **
  • Posts: 32
Re: Decocker sear slave pin length? Anyone know the length so I can make my own.
« Reply #3 on: July 19, 2016, 08:20:13 AM »
bleep. Thanks. I ordered it and the punch from CGW. But good to know. Yes it will be temporary. I'm disassembling the gun to cerakote it. I'm doing the frame first then the slide.
Logged

Offline schmeky

  • Hero Member
  • *****
  • Posts: 2897
Re: Decocker sear slave pin length? Anyone know the length so I can make my own.
« Reply #4 on: July 19, 2016, 10:01:43 AM »
Straight from our instructions:

The slave pin should be approximately .106? OD x .680" long with a radius on one end
Logged
Pages: [1]   Go Up
« previous next »