P-10Cs should be coming

[ragingbulldaily]

Because I'm learning a new gun I actually looked into the manual. I had high hopes it would give me a reference range as to what I can shoot. I've read people shooting everything from 115-147, but I want to do what's right for the gun so I can get the best performance out of my CZ.

[ragingbulldaily]

I liked these for the Glock.

[ragingbulldaily]

Let's say I pulled the trigger with one of the 135 grain in the tube, is it the pressure buildup that's the problem with it being so close to the rifling?

[dmossman]

I've shot a bunch of Hornady 135 Critical Duty out of all my CZs. Passes the plunk test and shoots great. It is my carry ammo of choice.

Sent from my SM-G930T using Tapatalk

[ragingbulldaily]

What's the negative side to having your bullet seat so far in it runs into the lands and grooves?

[Kenneth]

When you load a round that hits the lands and grooves the pistol won't go all the way into battery.

If it does then you won't be able to eject the round most likely.




Sent from my iPhone using Tapatalk

[ragingbulldaily]

Thanks for the information.

[eastman]

I've shot a bunch of Hornady 135 Critical Duty out of all my CZs. Passes the plunk test and shoots great. It is my carry ammo of choice.

Sent from my SM-G930T using Tapatalk

That is an easy test to do when evaluating a new type of ammo. SuperMatch uses a design of copper plated hollow point bullets that is not CZ friendly at the length that FM loads it. All my non-CZ pistols get to enjoy it (while it lasts).

[ragingbulldaily]

So I drop the round on the barrel, it goes plunk, then I twist the round to see if it grabs anything, then I tip the barrel upside down and it falls out clean. If it passes I'm good to shoot that ammo?

[ragingbulldaily]

Failed the plunk test. Doesn't drop out when upside down, and felt the lands and grooves when twisting... Life Will continue...

[armoredman]

If it's too long for yours, let it go. I use Critical Duty in the P-09, but Critical Defense in the SP-01 Phantom.

[ragingbulldaily]

Good advice, will do.

[Thepro788]

Also had a chance to play with the vp9, man, that has a really nice factory trigger. The magazine release is a bit stiff on the p10, trigger feels great, no grit. Range report this weekend. Picked up some Hornaday critical duty 135gr flexlock as well.

the vp9 has very tight tolerances and failed military arms channels drop in the water test. It was miserable and highly disappointing enough that I sold mine and picked up an fnx9.

[ragingbulldaily]

I personally am not a fan of the vp9 don't like the ears on the slide and don't like the loaded chamber indicator. Besides what I don't like, I was amazed at how nice it felt in hand and how nice/light the trigger was. I really couldn't find anything about the fn509 that I didn't like, maybe different on the range but in the store shop it rings a lot of bells

[O.B.B.]

I liked these for the Glock.

Wish I could find that front sight that would fit my PCR.