« previous next »
Pages: [1]   Go Down

Author Topic: Stock hinge pin  (Read 1482 times)

0 Members and 1 Guest are viewing this topic.

Offline KeithB

  • Jr. Member
  • **
  • Posts: 38
Stock hinge pin
« on: October 15, 2017, 11:36:29 AM »
As I saw on a previous post, my stock is not the only one to have the hinge pin start to walk out while shooting.  Did anyone find a fix for this?
Logged

Offline akuser47

  • Sr. Member
  • ****
  • Posts: 948
Re: Stock hinge pin
« Reply #1 on: October 15, 2017, 08:29:44 PM »
I would think you could stake the plastic to hold the pin. I don't remember what was come up with in the old thread on it.
Logged

Offline KeithB

  • Jr. Member
  • **
  • Posts: 38
Re: Stock hinge pin
« Reply #2 on: October 16, 2017, 12:26:07 AM »
The old thread did not have a solid solution.
Logged

Offline akuser47

  • Sr. Member
  • ****
  • Posts: 948
Re: Stock hinge pin
« Reply #3 on: October 16, 2017, 07:15:03 PM »
Figures maybe you'll be the first to make something work. please share what you find or figure out.
Logged

Offline romukom

  • Full Member
  • ***
  • Posts: 357
Re: Stock hinge pin
« Reply #4 on: October 20, 2017, 07:50:08 AM »
Here you go. There are several solutions you can pick.
http://www.czfirearms.us/index.php?topic=87675.0

Sent from my SM-T713 using Tapatalk

Logged

Offline Destructo6

  • Full Member
  • ***
  • Posts: 243
Re: Stock hinge pin
« Reply #5 on: October 20, 2017, 01:39:53 PM »
4mm O-1 tool steel rod from McMaster Carr for about $3 (3 foot length).

find a machinist to cut to length, round the ends, knurl a bit of one end, and harden, and Bob's your uncle.
Logged

Offline akuser47

  • Sr. Member
  • ****
  • Posts: 948
Re: Stock hinge pin
« Reply #6 on: October 21, 2017, 08:10:30 PM »
I thought I had been involved in this problem before lol.
Logged
Pages: [1]   Go Up
« previous next »