75b Hammer strut pin part number

[redlightrich]

Hello all, I am searching, and can't find the part number on CZ's site for the pin that holds the disco and hammer strut to the hammer. These are small black pins. This is for a 75B

I have searched CZs site, on all pistol types and find nothing. It may be that it has a dual use, and is labeled elsewhere.

Can someone assist with the CZ part number please,

Thank you

Rich

[Earl Keese]

I use p/n HPIN from Cajun Gun Works.

[cntrydawwwg]

I use same as Earl. But if factory is what you?re after.....
http://shop.cz-usa.com/ProductDetail/0420022001_Trigger-Pin-Short-7585-Pin-X2
   It?s the trigger pin according to the schematic. Part #9 is for the hammer and trigger. If you click on part description it takes you to the link for the part.
https://shop.cz-usa.com/czpartslists/CZ75B_fullsize_9mm.pdf

[redlightrich]

Thank you both, Thank you for the link Dawg!!!
I spent so long searching the site, CZ emptied my cart.
I already have the hard CGW pins, but I would only use them if they were tight in the bore of the hammer. I have had good luck with the factory part in the past.

If the CGW pin was very tight in the hammer bore, I may try their red loctite method, but I want to have both on hand before I start a job. I do hate when a 2 dollar item stops a project.

Happy New Year!!! Thank you again. I knew someone here would know this answer!!

Rich