Author Topic: EAA Witness help needed. No help in the clone section or CZ gunsmithing section  (Read 1292 times)

0 Members and 1 Guest are viewing this topic.

Offline dfariswheel

  • Newbie
  • *
  • Posts: 15
I posted this in the clone and the CZ gunsmithing forums and got no good help.........

I've been handed a Witness large frame 9mm that required a new interrupter installation.

After installation when the trigger is pulled in double action the hammer falls and is caught by the sear in the half cock notch.
I'm not sure what the fix is for this condition.
Any help??

In the CZ gunsmithing forum I was advised to trim the "wings" on the interrupter to drop the hammer SOONER.
This sounds counterintuitive. 
If the hammer is timed to drop sooner, wouldn't it catch on the sear worse, since the sear is already not rising up fast enough for the hammer to not catch.

Help........

Offline Grendel

  • Administrator
  • Hero Member
  • *****
  • Posts: 8955
  • 'Live Long, and Prosper'
You already have two other threads, including one with a possible fix. That's plenty.
Corruptissima re publica plurimae leges - Tacitus

Inter arma enim silent leges - Cicero

I wasn't born in America, but I got here as fast as I could.