71
CZ CLONE CLUB / Re: SAR P8S
« Last post by jwc007 on April 26, 2025, 07:18:37 PM »Correct me if I’m wrong, but both of those uppers should work on that frame. The orientation of the locking lug in reference to the slide lock/release pin should be the same, correct? That is, as long as the safety and everything else functions properly.
That is correct! Here is a pic of the SAR B6P and the SAR K2P/CM9 G1 with their Slide Assemblies and Frames swapped. Note that they were also test fired and functioned perfectly.


SAR B6P and K2P/CM9 G1 Slide Assembly swap
Thanks for clarifying that, jwc. I don't have a P07, so that was the closest comparison that I had personal knowledge of.
You are most Welcome!

Now back to discussing that fine SAR P8S you have!
