Got my S slide stuck on my C frame....

[HorribleAim]

So like the title says I was playing around seeing how this combo would look with a brake and well now it?s stuck. Not sure how to get it off and it?s not like a Glock so I?m confused

[HorribleAim]

[HorribleAim]

[AVinLo]

Dont think I can help you.....just saying. But, wanted to comment I like the look of your gun. Have P09 since 11/18 and still new to CZ. Hope someone can help you out.

Sent from my SM-G965U using Tapatalk

[seebee62]

Maybe contact CZ or a Gunsmith.




Sent from my iPhone using Tapatalk Pro

[HorribleAim]

     Hiya Horribleaim and thx for the thread. I got a similar idea with my Tanfoglio and tried it on po-2,shadow,and 75b frames...two outa three didn't get jammed on tho. I just kept at it till one combination of push,pull,drop,or tug worked. Do repost when ya solve the problem,I don't want anyone having trouble sleeping not knowing. Cheers

Gonna be a long night then lol

[HorribleAim]

I removed the striker and still stuck... I tried to stick something in the frame to push down the slide release spring but there isn?t enough of a gap to do it.

[armoredman]

I'm thinking you might want to contact CZ.

[HorribleAim]

🥺 my pride says I can figure it out but all logic says you?re right.

[Tyerone]

Stick in freezer over night? Then try?  Soak in a bowl or motor oil first, then bag and freeze?  Grasping at straws.  Tap with rubber mallet. ...

[Tok36]

Ahh, pride.... the root of many a broken thing. I agree with the above suggestion to call CZ-USA. They may even get a kick out of the question, I'll bet that your situation does not occur that often.

[KFD147]

You are probably going to have to pull down the take down tabs pretty hard and smack the back of the slide with a dead blow mallet. Or possibly take out the take down plate and try to get it off.

Sent from my Moto Z (2) using Tapatalk

[HorribleAim]

So I got it off, the recoil spring gets stuck in a notch right in front of the take down lever. Now the guns going back to cz because while test firing it I was having a dead trigger, sluggish reset and some issues when I took it apart again. I do have an HB industries trigger show so I?m not sure if that with the 3 lbs striker spring is doing it but idk. Thoughts?

[armoredman]

i would suspect possibly damage from the improper assembly, and CZ will probably cover it under warranty.

[dwhitehorne]

When I first got a HBI trigger I out the lighter 3 pound striker spring in. I was having reset issues. I wasn?t sure if the striker spring was to light or if the sides of the trigger were rubbing the opening in the frame. I took a small file to the sides of frame the trigger goes through and I also went up to the 3.5 spring. Never had an issue with reset after that.  I would put the factory springs back if you decide to send it back to CZ.  David