Author Topic: Any P10C Striker failures running HBI reduced power striker springs?  (Read 78 times)

0 Members and 1 Guest are viewing this topic.

Offline nick779

  • Jr. Member
  • **
  • Posts: 42
Im just curious if anyone here has broken a striker tip using anything lighter than the stock spring. According to a few detailed posts and tests I had found, the factory and HBI 3.5# are about the same compressed strength, but the 3# is about 75% power. Im wondering if this has an effect on how much it stresses the striker especially in dryfire.

Has anyone had a FP failure in their P10C using the 3# reduced power spring?

Spring rate test courtesy of our forum mate earlan357: http://minivandoorgunner.blogspot.com/2017/09/cz-p-10c-striker-spring-and-hbi-trigger.html