« previous next »
Pages: [1]   Go Down

Author Topic: Stuck P01 sear cage....  (Read 1240 times)

0 Members and 1 Guest are viewing this topic.

Offline briang2ad

  • Hero Member
  • *****
  • Posts: 3302
Stuck P01 sear cage....
« on: February 03, 2021, 02:22:22 PM »
Did this a few weeks ago - no hitches.

Got the decocker OUT of the gun, and took out the little round plate that holds the sear cage pin in. I CANNOT move the pin that holds the cage in AT ALL - won't budge.  Normally you can start it out with a tiny bit of pressure with your slave pin - it won't move - even  when taping with a hammer. 

Wassup?  thanks.
Logged

Offline Tok36

  • Hero Member
  • *****
  • Posts: 6243
Re: Stuck P01 sear cage....
« Reply #1 on: February 03, 2021, 06:09:57 PM »
I would jiggle the parts in the Sear Cage around a bit with a pointed metal probe to free things up. Then brace the psitol frame on something real steady and tap the pin out with a steel punch and hammer or drive in the slave pin.
Logged
Will work for CZ pics! (including but not limited to all CZ clones)

Offline SI VIS PACEM PARRABELLUM

  • Hero Member
  • *****
  • Posts: 5874
Re: Stuck P01 sear cage....
« Reply #2 on: February 03, 2021, 06:20:05 PM »
I hate to ask because I know you've done this before but you are trying to remove the sear cage pin from right (ejection port side) to left? I've never had one stick that way seems pretty strange.
Logged

Offline briang2ad

  • Hero Member
  • *****
  • Posts: 3302
Re: Stuck P01 sear cage....
« Reply #3 on: February 03, 2021, 06:40:09 PM »
Gents:  Thanks again - got it out.  Yes from the right tom the left.  Doh!  I had to jiggle and tapped with a punch.  It was just tough lining all up.  Last time I was able to do it with hand pressure on the slave pin. 

Now I'm snake bitten for the way back! 
Logged
Pages: [1]   Go Up
« previous next »