HB Industries P10 trigger

[nova3930]

Got a Tungsten variant in today. I'm liking the color for a two tone pistol. Hope to get it installed by this weekend to give it a full evaluation.



Sent from my SAMSUNG-SM-G930A using Tapatalk

[armoredman]

Very nice!

[Craig M Arnold]

Now that is a great looking trigger.

Best regards.

[nova3930]

Installed now. Hope for trigger time this evening

Nate Whitfield
NAAH Tool Works
Naahtoolworks@gmail.com
Naahtoolworks.com

[nova3930]

Couple hundred down the pipe this evening. Gotta say it's a winner. I've never been able to rip off a full mag that accurately that quickly.

Nate Whitfield
NAAH Tool Works
Naahtoolworks@gmail.com
Naahtoolworks.com

[Thebillsman]

Probably going to grab one of these in the upcoming days. I've never been one to change the actual trigger on my edc and tbh it makes me a tad nervous. The install looks easy enough and putting the trigger through its paces with a couple hundred rounds is no chore.

[shookscustoms]

Love mine. No rounds through it yet, but with the 3# spring, it feels great.

[Thebillsman]

Love mine. No rounds through it yet, but with the 3# spring, it feels great.

I heard (even in this thread) that there were some light primer strike issues with the 3lb spring. HBI, when asked about it, says in the comments section of their install tutorial video on YouTube that they experienced issues with that spring. It might feel great but won't perform great. This is my issue when looking for a reliable edc.

They claim the 3.5lb is 100% reliable but the change in trigger pull weight is a wash so why even risk it? I don't know if I'm overreacting.. since the trigger bar, disconnector and striker spring geometry all remain the HBI shouldn't really effect reliability?

[nova3930]

I just left the stock spring in mine and am more than happy with it. Once I finish my run down it will graduate to being my primary carry.

Nate Whitfield
NAAH Tool Works
Naahtoolworks@gmail.com
Naahtoolworks.com

[nickshawn]

I put the 3.5# in mine and it seemed to drop the trigger pull a bit, I'd have to go back and check my notes to be sure. 200 rds so far without a hitch.

[Dzldust]

[chadbrochills]

Anyone know why when you go to the HBI site it shows only 4 colors, but on CZ Customs they have a bunch of colors, but no burnt orange?

[Toby196]

Anyone know why when you go to the HBI site it shows only 4 colors, but on CZ Customs they have a bunch of colors, but no burnt orange?

I was wondering the same thing.

[DOC 1500]

I'd be willing to bet that the manufacturer had multiple colors and CZ Customs bought the multiple colors but now the manufacturer is out of supplys and  CZ Customs still has their supply.

[nova3930]

Anyone know why when you go to the HBI site it shows only 4 colors, but on CZ Customs they have a bunch of colors, but no burnt orange?

Because either

A. If you buy enough of something most manufacturers will accommodate you or

B. Cz custom bought them in the raw and anodized themselves

Nate Whitfield
NAAH Tool Works
Naahtoolworks@gmail.com
Naahtoolworks.com