« previous next »
Pages: [1]   Go Down

Author Topic: SRS 1 install question on a PCR  (Read 1514 times)

0 Members and 1 Guest are viewing this topic.

Offline CZDad

  • Full Member
  • ***
  • Posts: 259
SRS 1 install question on a PCR
« on: February 18, 2018, 04:21:10 PM »
I have started to do the install work of a CGW SRS-1. This is on a PCR.   The directions seem easy enough, and I got started eagerly. 

I'm getting ready to remove the sear cage pin. When I notice that on the left side the frame.  It doesn't look big enough for the pin to be removed.



All the other pictures of this process I've seen does not have this.  It's just a pin to be driven out.  Am I missing something?


Thanks!

-CZDad
« Last Edit: February 18, 2018, 04:24:23 PM by CZDad »
Logged

Offline cntrydawwwg

  • Hero Member
  • *****
  • Posts: 5254
SRS 1 install question on a PCR
« Reply #1 on: February 18, 2018, 05:05:48 PM »
It?s a disk to help hold the sear pin in. ( actual part is called ?fixing insert?) Place a punch on the edge of the inner hole and tap it out. Make sure to put it back in when putting back together. Should slide back in, sometimes I use a punch and push it in.
« Last Edit: February 18, 2018, 05:08:53 PM by cntrydawwwg »
Logged
If guns are outlawed.........
 Only outlaws will have guns.

Offline CZDad

  • Full Member
  • ***
  • Posts: 259
Re: SRS 1 install question on a PCR
« Reply #2 on: February 18, 2018, 05:08:20 PM »
Awesome Thanks! @cntrydawwwg
Logged

Offline cntrydawwwg

  • Hero Member
  • *****
  • Posts: 5254
Re: SRS 1 install question on a PCR
« Reply #3 on: February 18, 2018, 05:09:17 PM »
Most welcome.
Logged
If guns are outlawed.........
 Only outlaws will have guns.
Pages: [1]   Go Up
« previous next »